Standard Model Number Description EN 61010-1-2001, Figure 8; IEC 60601 BBA20 2mm hole for thermocouple applications EN 61010-1-2001, Figure 8; IEC 60601-1, Figure 48; IEC 60335; IEC 60950 BPA10 J 335/2-ANCE; UL50E; CSA22.2 No. 94.2 50E GT IEC 60065, 60950 ITB2A 600mm IEC 60068-2-75; IEC 60335; IEC 60598; IEC 60601; IEC 61010 F22.50 length 350 mm, diameter 50
This high quality precision pin probe is supplied in accordance with all IEC standards listed below. The Test Pin Probe, Model TPP15, is used to test for accessibility of small objects and meets IEC, CSA and UL requirements. Ergonomics designs and manufactures these probes in our own facilities, ensuring top quality parts at a competitive
Incline Plane — Model IP01 The Incline Plane, Model IP01, has been developed in accordance with established product safety standards. Standards such as IEC 60950 and others require product testing at an incline of either 10 or 15 degrees. Test surface is 900 X 870 mm and close to floor for easy access
The Gasket Test Apparatus is used to check the integrity and endurance of gasket materials used in a Type 2, 3, 3Rm 3S 4, 4X 5, 6, 6P 12, 12K or 13 enclosures. The requirements are listed in clause 8.13.3.3 and is referenced as the Compression Test Gaskets used on enclosures for electrical equipment. The
Leverage our experience with designing and fabricating a complete impact test system. Do not waste time trying to figure out all the components required to perform the testing, and eliminate any uncertainty that the test complies with the standard testing requirements. Ergonomics offers a turnkey solution that can be used for testing immediately upon delivery.
The Impact Test Ball is a specially machined ball to test impact resistance according to IEC, CSA and UL Standards.
T4-42 (1000V) TRACKING TEST APPARATUS is intended for determining the degree of protection against formation of conducting paths in solid insulating materials, due to the electric stress and electrolytic contamination of the surface.
T4-41 (600V) TRACKING TEST APPARATUS is intended for determining the degree of protection against formation of conducting paths in solid insulating materials, due to the electric stress and electrolytic contamination of the surface.
The Scratch Tester, Model ST10, has been developed in accordance with product safety standards IEC60950 and IEC60065. It is used to determine the effectiveness of insulating coatings on printed wiring boards and anywhere the robustness of coatings is important. The cart is designed to hold the pin at 80°- 85° and the mass provides the
For abrasion resistance testing. IEC 60950 and 60065
The Base for the Ball Pressure Apparatus supports the Ball Pressure Apparatus during testing. It is made of stainless steel, with a 2mm hole for thermocouple applications. The base complies with all standards requiring the use of a ball pressure apparatus